Yahoo Suche Web Suche

Suchergebnisse

  1. Suchergebnisse:
  1. The film tells the story of biodiesel, an alternative fuel for diesel engines. Made from vegetable oil, it is non-toxic, has low carbon dioxide emissions and can ultimately replace all liquid fuels used in the United States, thus freeing America's dependence on oil needed for gasoline. —Arthur Hausner

  2. CMC Klebetechnik offers as standard for EME/MEA assembly in PEM cells a PEN - film with a heat-activated adhesive ( CMC 61325). The film and adhesive are hydrolytically stable and can therefore be used permanently in fuel cells. The adhesive used allows a very narrow lamination surface of the retaining film on the actual functional membrane.

  3. 15. Feb. 2019 · While the deposited fuel film mass and area are constantly decreasing with increasing ambient temperature the effect of the ambient pressure on the film formation is more complex. Here, with an increase of the ambient pressure from 0.4 bar to approximately 3.5 bar the fuel film mass and area are increasing. Therefore, turbocharging can lead to ...

  4. 24. Okt. 2023 · The fuel film thickness was found to be quite small, less than 10 μm, for both motored and fired conditions performed at the same piston temperature. The 2,3-hexanedione was found to leave a ...

  5. 12. Apr. 2011 · Fuel film has been known as a source of emission outcomes as it is hard to achieve complete combustion in the peripheral area of the film. Although the global properties such as film mass, area ...

  6. 12. Sept. 2018 · Parametric studies are further conducted with various initial temperatures of 600–800 K, pressures of 7–15 atm, fuel film and wall temperatures of 300–400 K. By comparing the cases with an isothermal dry wall, it is found that the existence of a wall film always promotes flame quenching and causes more emissions. Although quenching ...

  7. 30. März 2023 · Abstract Flame spread over a thin film of various liquid fuels with an flash point below ambient temperature has been studied experimentally using thin copper and thick glass substrates in environments with different oxygen concentrations. It has been shown that with an increase in the oxygen concentration, the flame speed increases faster than the normal speed of the corresponding homogeneous ...