Erhalten Angebote für {kewyord:ähnliche artikel} auf Amazon. Entdecken tausende Produkte. Lesen Kundenbewertungen und finde Bestseller
- Amazon Prime
Bei Amazon ist für jeden etwas
dabei. Registrieren Sie sich jetzt!
- Kostenlose Lieferung
Jetzt bei Amazon bestellen und
kostenlose Lieferung sichern!
- Amazon Prime
Suchergebnisse
Suchergebnisse:
Dead time. For detection systems that record discrete events, such as particle and nuclear detectors, the dead time is the time after each event during which the system is not able to record another event. [1] An everyday life example of this is what happens when someone takes a photo using a flash - another picture cannot be taken immediately ...
This is accomplished via handshaking between the gate-to-source voltage of the high-side and low-side gate drivers, which is internal in integrated MOSFET drivers. Dead time is dependent on the slew rate setting of the device, and it is specified with typical and maximum values. Figure 3-1.
2.1 Basics of dead-time calculation. To calculate the control dead time, use the following equation: tdead = td_off_max − td_on_min + tpdd_max − tpdd_min ×. (1) Where, td_of_max is the maximum turn-of delay time. td_on_min, minimum turn-on delay time. tpdd_max, maximum propagation delay of driver.
17. März 2015 · The dead time is the period at which no part of a H-bridge driver is turned on. It is used when you have two complementary PWM signals (one on when the other is off) so that neither the high nor the low side of the H-bridge can be conducting at once.
Die Totzeit eines Teilchendetektors ist eine Zeitspanne unmittelbar nach dem Nachweis eines Teilchens, während der der Detektor noch nicht wieder bereit ist, ein weiteres Teilchen nachzuweisen. Dadurch wird, falls zwei Teilchen kurz nacheinander eintreffen, das zweite nicht registriert. Je nach Art des Detektors und der an ihn ...
3.2 Four Methods for Dead-time Measurement. As described above and shown in EC table as well, two Dead-times need to be tested, Dead-time from HS FET off to LS FET on and Dead-time from HS FET on to LS FET off. Based on TPS51225EVM, here are four methods for Dead-time measurement. 1.
Dead time. Lag time refers to a damped response from a process, from a change in manipulated variable (e.g. control valve position) to a measured change in process variable: the initial effect of a change in controller output is immediately seen, but the final effect takes time to develop. Dead time, by contrast, refers to a period of time ...
ebay.de wurde im letzten Monat von mehr als 100.000 Nutzern besucht
Jetzt neu oder gebraucht kaufen.
